LeetDesk Entry
Manual
Step-by-step instructions for setting up and operating the LeetDesk Entry.
Content blocked
Accept marketing and statistics cookies to show the underlying content (e.g. YouTube videos or Google Maps).
The following components are included in the LeetDesk Entry package:
Schritt 1 & 2
Insert a hexagonal crossbar into the motor and a table leg, and fasten the motor to the table leg using 2 M6*10 machine screws. Use 4 M6*10 machine screws to attach a part of the outer rail to the table leg. Repeat this step with the second table leg.
Schritt 3
Attach the foot extensions using a total of 8 M6*30 machine screws.
Schritt 4
Insert the middle rail piece into the two outer rails. Ensure that the opening faces the ground.
Schritt 5
Insert the hexagonal crossbar into the connecting piece, then insert the second hexagonal crossbar into the other side of the connecting piece. Finally, insert this end of the hexagonal crossbar into the table leg.
Schritt 6
Fasten the cross rail to the middle rail piece with an M6*30 machine screw. Make sure the cross rail is correctly oriented.
Schritt 7
Attach the side brackets to the table legs using 4 M6*10 machine screws.
Schritt 8
Use the 3 wooden dowels to connect the two halves of the tabletop. Then, screw them together using the two flat connectors with a total of 4 ST5*16 wood screws.
Schritt 9
Screw the table frame and the handset together with a total of 22 ST5*16 wood screws. Attach the power supply using the two double-sided Velcro stickers.
Schritt 10
Secure the middle rail piece with 4 M6*10 machine screws. Secure the hexagonal crossbars to the connecting piece with 4 M5*4 machine screws.
Schritt 11
Connect all the cables according to the schematic diagram.
Fertig
Congratulations, you are a proud owner of a fully assembled LeetDesk Entry!
READ THIS IF YOU PURCHASED THE PC HOLDER
⚠️ WARNING: If you have purchased a PC mount along with the LeetDesk Entry, please use the shortened screws included in the add-on box to attach it to the desk. Under no circumstances should you use the screws provided in the packaging of the PC mount itself, as these are too long for the LeetDesk Entry and may potentially damage the tabletop!